|
Re: Seeker Stand for Earthrise Seekers? Need Help Pls
I'm started to just make my own.
Just a small plexiglass (acrylic) piece, cut it right, drill a 3 mm-ish hole and a nail that is about the right size (but smaller.. something like 2.75mm), epoxy it together, and put a put of epoxy on that nail to create a layer (if too much, it's epoxy so you can file it down) .
This thing can support just about anything now. and is about 12 inch high. I'll probably do others that are not as high.
I'll probably do some that can be taken apart to store if needed, it'll just take a few extra pieces that I'll make "snap" together.
But I have several "cheap" that have both the 3mm pin or "claw".. and they've been fine for most. just a bit wobbly and take a bit of patience to set them "just right".
__________________
If I don't reply to you, and if your comment was tasteless, immature, trollish or such, you're probably on ignore already, congratulation for making it on the list. Life's too short.
Last edited by imfallenangel; 08-28-2020 at 09:10 AM.
|
