Quote:
Originally Posted by Mumps
Pretty much. The hinges on the wings are bent outwards, and there is almost no friction holding them on place. Heat up the part, and bend the parts into their intended position.
I would recommend using a pair of silicon tipped kitchen tongs to grab the part, and a pair or needle nose pliers to bend the part to prevent burning yourself, because it's very easy to burn yourself! The boiling water is the safest method, as there is less room for error. I just used a heat gun because I have one and am very confident using it.
|
Thanks! Ya my wife's hair dryer is usually good enough for what I need to get done. But will see once I finally get him out of his packaging.
