ROTF Stressmarks

[Icetron]

Just wondering, anyone else experiencing this on their toys?

I have the problem mostly on Ransack and Demolishor.

On Ransack I have no idea how that stressmark got there, but I've picked up a replacement.

However on Demolishor it's a bit hard to avoid holding that spot (the railings) when I try to get him back into alt mode.

Wheelie has a minor problem with the front of the car too, but that one is fine if you're careful.

I haven't had much problems in previous lines regarding stressmarks. I'm sort of careful with my figures too.

[astrana]

i dont have stressmarks on ransack, but his joint did get very loose

[Icetron]

Yeah my ransack has really loose joints too...

[chans formers]

i too have the same stress problems in the exact same spots on rotf demolisher's railings.

[Icetron]

Dang, I'm guessing the problem is pretty common with Demolishor. I'm seeing it a lot in closeup pics. It's not really noticeable outside of alt mode but I like all of this guy's modes so it's a little frustrating.

[astrana]

i found these stress marks on my demolisher too, dam you for pointintg that out

[Icetron]

Sorry! It just bothered me when all my toys were 'stressing out' haha. I wish they just used regular hard plastic for those parts on Demolishor. Makes me kind of worried that some of Mix Master's parts will do that too, even though they're a bit thicker.

[Sun Swipe Prime]

I'm not having issues with Ransack, and I've been transforming him at least every other day. As for joint looseness. Mines pretty tight. Here's a pick of him showing off his tighness. Sorry for the low quality, but you get the idea. He's standing all on his own.

[DECEPTICON_BRAWL]

on my mudflap those flappy thingys on each side of his torso have stress marks.i'm always worrying that its gonna break

[Echotransformer]

For the very brave, stress marks can be faded or virtually eliminated with a heat gun. Very carefully heat up the affected area only, and the stress will fade. Careful, if you get too hot you'll reach the melting point of the plastic.

It's good to test on some beater TFs first.

I've fixed quite a few TFs this way (melted a couple too :-)