Combiner Wars/Generations

[down_shift]

A little something for the haters

CW Voyager Cyclonus (remold of Silverbolt)





CW Viper (Powerglide Repaint into Cobra Rattler)





Someone is on a hot streak!

[UltraPrimal]

Whoa! I know there was a Cobra Rattler Powerglide repaint rumored, but was there a Cyclonus too? I think this is the first seeing/hearing about it.

I hope Hasbro has a Leader Galvatron in the works because Universe 2.0 Galvatron is going to look even smaller next to this guy!

[Buhawi]

Originally Posted by Shockwave 75

How did you cut the fingers?

Here: I just quote myself from the other boards.

Originally Posted by seali_me

I hate removing pins and avoid it like crazy.

BUT the pin teeth in proportion with the plastic holding it is thin. It was an easy thing to do since you can knock it out with one hammer hit. I used a nail and hammer.

Originally Posted by seali_me

I used a hobby knife and an old cutting board.

The first cut per finger: I would stand up the fingers cut half through in between the tips of the fingers

Second cut: I then set it down plastic lines in your view then cut again from there. Cut each finger until done.

I push back the pin just by small force non-teeth first and just push from behind the side with teeth.

Once free each individual finger is now articulated.

[Supernova]

That's definitely the closest possible confirmation we could get outside of an official announcement.

That said, I can't possibly see me replacing my RtS Cyclonus for this guy. He's not perfect, but he's really damn good in my eyes.

Also, what combiner would come from Cyclonus as a torso?

[Sun Swipe Prime]

Originally Posted by Supernova

Also, what combiner would come from Cyclonus as a torso?

They could repaint the aerialbots into Cyclonus's armada.

[Buhawi]

Because it's tradition...

[Undrave]

I for one can't wait to get the other Stunticons! Off-Road and Dead End more than Breakdown though.

[CanBot]

Speaking of Stunticons...is it going to impossible to collect them until all the waves come out?

As much as I tinker with the idea of getting ALL the combiners (autobots as well), I'm thinking perhaps I'll just grab Menasor and, if he's released, Bruticus. And Devastator of course.

But if they don't release them in sets, then it'll make things difficult.

[Larkhainan]

The next wave is 2:2:2:2 with the remaining 3 Stunticons and Air Raid two each, then the wave 2 revision is 1:1:2:2:2 with the 3 Stunticons two each, 1 Air Raid and 1 Drag Strip in case you missed him. Should be pretty easy to finish both.

[Undrave]

Originally Posted by CanBot

Speaking of Stunticons...is it going to impossible to collect them until all the waves come out?

As much as I tinker with the idea of getting ALL the combiners (autobots as well), I'm thinking perhaps I'll just grab Menasor and, if he's released, Bruticus. And Devastator of course.

But if they don't release them in sets, then it'll make things difficult.

I preordered the set of 4 (Air Raid and the 3 Stunticons) from BBTS. I didn't want to wait until July for that wave to show up around here or something. I knew Dragstrip would be easy to find.

Now I'm wondering if I should do the same for Motormaster and Black Jack.