Heavy Mods & Scratchbuilds Classic's Galvatron how to

[aprim]

Hey Guys, a member asked me to post a "how to" on my classic Galvatron so here it goes.

First I used a Classic or Henkei Megatron, I made 2 of these. One was sold and one I keep on my shelf.

Classic Megs Upper body Head forearm x2
Classic Treadbot(second version legs)
Original G1 Galvatron (Cannon and Stabilizer)
Enegon Snowcat (treads and Chest)
Aproxy Sculpt Head Horns
Bonicle pieces for the leg gaurds
Magnets small
GIJOE ROC Drill vehicle for cannon front.
The squares in the abs section was from a Godzilla figure that I cut up. It had those patterns on it.

1st Version, no retractable Legs




Parts Used,


1st version was ok, as you can see the Legs look weird in cannon mode so I thought Treadbolt retractable legs would come in handy.

Galvatron 2 Cannon I used a GIJOE Drill vehicle for the front. Original G1 Crown and red “shoulder pads” to try and look more accurate.






Here is a pre paint pic, as you can see I molded the crown and the shoulder pads on the sides of the head.
Also switch a forearm with another megs so they both are the same.



Legs Treadbolt


Back here I used a Universe Countdown but liked the G1 Galvatron much better


Finished, (Encline Design Did the paint for me on this one)




Here he is with the Original G1 Back piece on.



Hope that helps!

[zuffyprime]

OMG. Wow.
amazing, thanks for sharing.

[Cliffjumper69]

Damn that Energon Black Zarak is sexy

[Vain]

That's rockin'! I'm fairly jealous!