Cybertron.CA - Canadian Transformers News and Discussion
Go Back   Cybertron.CA - Canadian Transformers News and Discussion

View Single Post
Old 08-31-2018, 12:01 PM   #7
JonoPrime
Robot Master
Join Date: Jul 2007
Location: Ontario
Posts: 728
Re: Pain and frustration with Dinobot upgrade kits (PE & TCW)

Quote:
Originally Posted by cr3d1t View Post
Or I could just buy a new Slag and Sludge. Seems cheaper, even if it’s another hit to the wallet.

Messed around with the smaller accessories. Swords and guns fit okay, but Swoop’s missile pods don’t fit in the slots on the wings. The tabs are too big. I’ll have to shave/sand them.

If sanding a tab or peg, is coarse or fine grain better?
Id start with a finer grain and give it a go. That way you dont take off too much plastic. And if its not quite doing the job, Id slightly up to a coarser grain and see how that works out. ... Worse case you take off too much of the plastic you could always dab the area with either some instant glue/clear nail polish/Future floor polish to thicken it back up.
JonoPrime is offline   Reply With Quote
 
Transformers Shopping







Donate to Cybertron.ca
Donations keep this site running, thanks for your support. More details here.

Powered by vBadvanced CMPS v3.2.3

All times are GMT -4. The time now is 07:41 AM.



Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.