Cybertron.CA - Canadian Transformers News and Discussion
Go Back   Cybertron.CA - Canadian Transformers News and Discussion

Thread: Repaints & Minor Mods G1 Grimlock help!
View Single Post
Old 07-06-2014, 10:53 AM   #3
chans formers
raff ow roud
chans formers's Avatar
Join Date: Mar 2008
Location: calgary alberta
Posts: 7,289
Re: G1 Grimlock help!

if you have a soldering iron,heat the screw from the back side.after a few seconds,it should "crack" the seal that it formed from 30 odd years of being there.luckily his crew is an easy to access area by not being stuck down a tiny/narrow channel/hole surrounded by plastic.
just make sure you're using the right sized phillips screwdriver because if you strip out the screw by using a too small phillips,your next resort is to knock the pin out of his dino spine which holds the two dino chest halves and swap out the dino chest halves completely.(by dino chest halves i mean the two big chunks his dino arms are mounted on and cover his bot mode head in dino mode)

hope that helps
__________________
now open for commissions...big and small...minor and heavy,you dream it,i make it.
chans formers is offline   Reply With Quote
 
Transformers Shopping







Donate to Cybertron.ca
Donations keep this site running, thanks for your support. More details here.

Powered by vBadvanced CMPS v3.2.3

All times are GMT -4. The time now is 10:37 AM.



Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.