Re: G1 Grimlock help!
if you have a soldering iron,heat the screw from the back side.after a few seconds,it should "crack" the seal that it formed from 30 odd years of being there.luckily his crew is an easy to access area by not being stuck down a tiny/narrow channel/hole surrounded by plastic.
just make sure you're using the right sized phillips screwdriver because if you strip out the screw by using a too small phillips,your next resort is to knock the pin out of his dino spine which holds the two dino chest halves and swap out the dino chest halves completely.(by dino chest halves i mean the two big chunks his dino arms are mounted on and cover his bot mode head in dino mode)
hope that helps
__________________
now open for commissions...big and small...minor and heavy,you dream it,i make it.
|