Siege add-on kits and parts
Hey - I recently purchased a 3D printer after just getting back into collecting Transformers. My projects will be posted here which have been mainly for the Siege figure line (because that is all I have so far).
Parts are printed in colors of material I currently have on hand and shown without any paint apps. Kits are available to purchase. Send me a message to inquire. Pricing will range from $15 to $25
I am open to and encourage all feedback/suggestions (good or bad) and requests. Let me know what you think!
First kit to show is Ratchet. Parts listed below.
2x lower legs (inside knees)
2x knees back side
2x feet (bottom)
2x forearms (inner)
2x biceps (inner)
6x 5mm port filler (4x arms, 2x lower outside leg)
1x back
Last edited by 4TonMantis; 10-08-2019 at 11:15 AM.
|