Quote:
Originally Posted by DinobotsDestroyU
Great job bro! Was it hard to wire the LED lights? I never bothered, always seemed like a headache
|
It was a little difficult as I'm not very good at soldering but I managed. Just got to take your time, take some rough measurements and give yourself a bit of extra wire just in case.
What I ended up doing was running a positive and negative wire up the length of the unit and branching off at each level. At each section, I stripped the wire running the length soldered the wires running from the LED strips and heat shrink them.
You can also do the same thing using these blue crimping connectors I got from Canadian Tire.
