|
Re: Combiner Wars Devastator: Q/C Issues Lookout/Thread
I would try both. Hair dryer to soften the general area and the heated pliers for more targeted softening and deforming. I advise lots of patience. Steadily increase the heat through repeated attempts as the melting point of this plastic is quite low and it'ss actually quite easy to burn.
I don't believe heated pliers alone is sufficient as these plastics are poor conductors of heat. You may end up melting one part of the tab while the other part stays cold.
Last edited by OldOfflineMan; 07-27-2019 at 06:16 PM.
|
