Quote:
Originally Posted by Echotransformer
I would actually use very warm water vs. oil...oil, if not properly cleaned after, will be hard to paint. Here's what I'd do:
-diassemble the legs as much as possible, to isolate the parts and have as little metal as possible (i.e. remove screws, pins etc.)
boil water (in a kettle)
hold the part safely...usually with pliers
pour the boiling water over the plastic part to remove
attempt to remove the part (sometimes gloves are needed, be very careful!)
This works pretty much every time.
|
Soap and water bub.
Doesn't stay on plastics when cleaned properly.
Veggie oil is different than pledge or abrasive stuff