Canadian Transformers News and Discussion Forum

[Ozrein]

Originally Posted by imfallenangel

And I'm sure that most members would say the exact same thing when it comes to the transformation of most figures, it's nothing special...

For myself, I don't bother with the instructions because to me, they are impossible to read/view well in the bland back and grey monochrone print that they've been doing for the last few years... and with close to 99% of the figures I get, there is absolutely no issue in figuring it out, but I will watch reviews to see how others view the figures and in case I might have missed something as I don't assume that I can't miss something.. heck, with Siege Prime, I never noticed the folding section in the legs for the extra 5mm port that could be used for a trailer until much later simply because it's well hidden.


And again, some are challenging enough to require a viewing to see what we miss to get it done... nothing special there either.

It's good for you if you have one that you don't appear to have the same difficulties that many have had, as maybe your figure has looser pins and such or put together better at the manufacturing level than others may have been. I have a few multiple of some figures and I do have some that one of them is perfect, it snaps well and everything aligns, while another of the exact same figure refuses to snap correctly so some parts are misaligned. Considering that we are taking micrometers' worth of difference with a used mold or just a pin that went it just a tiny bit off (my 30G Sandstorm's arm has a pin that very crocked, and while it still transforms and moves correctly, it doesn't snap perfectly like the other arm). My Siege Ironhide refuses to close the back panels of the truck's back (the legs) simply of a tiny issue with the mold that I can't locate to try and correct by either cutting or grinding a part (which I already tried a few spots).

Same with Ultra Magnus, his shoulder sections, the grey piece will snap perfectly for some, mine didn't at all, I could NOT snap them locked so they'd fall off, so I very gently sanded the tabs until they finally did close and lock the parts in place (which makes a world of difference).

So again I'll repeat as you seem to have missed reading that part: the OP and many comments are NOT about how to transform it, but that it requires to be very specific about alignment of some part as otherwise it doesn't snap together properly. That is confirmed by several members including myself and I would not assume anything about their skills at transforming their figures at you did.

Again, sorry if my post offended you. It was not the intent, but apparently my wording was taken in a way that could be deemed offensive.