this post is two fold.
it's both to show how it all joins to him and to somewhat provide the commissioner with "instructions" lol....
from standard bot mode,point his toes right down until they click.
on the feet armor,swivel the back peg support to 45 degrees.
the peg plugs into a new fused in hole on his toe bottoms which are now facing backwards with the toes pointed down.
once the peg is in all the way,push up on the whole foot pad until it seats the front of his toes flat to the top of the new feet armor.
http://i272.photobucket.com/albums/j...psfcne8yd1.jpg
to attach shin guards, each shin guard has x3 supports.
plug the single support right between the two back wheels first.
the other side that has two supports actually fit and click into both a certain upper groove and the giant square hole located on his lower inside leg.
this shot shows the single support already in the wheels and the double support at the verge of being clicked in.
http://i272.photobucket.com/albums/j...psbyzopkoe.jpg
with all three supports fully clicked in.
http://i272.photobucket.com/albums/j...psg25t7bj3.jpg
for the chest armor,there's two holes on the two upper tabs,these slide onto his stock exhaust stacks.keep in mind to always only press or lift on the backs of the tab and stay away from adding stress to where the tabs meet the actual chest armor.
http://i272.photobucket.com/albums/j...pshkfuwuny.jpg
http://i272.photobucket.com/albums/j...psdjc186hj.jpg
under each forearm armor,it simply pegs into his stock hands like guns.
keep in mind to line up the side flap of them.the side flap both adds left to right support and fills in the massive stock gap between his fists and the flip down truck sides.
http://i272.photobucket.com/albums/j...pscvhjgxti.jpg
http://i272.photobucket.com/albums/j...psr8yidk8q.jpg
to attach shoulder armor,click them in from back to front.
on the back lower inside,there's a small lip which actually locks them into place by hooking to the bottom of the stock bug deflector(silver chunk)which in bot mode ends up on the backs of his shoulders.
make sure the very bottom lower outside support is flush with the outsides of his stock shoulders and it'll all only just fit the one way.
http://i272.photobucket.com/albums/j...psiremgvzw.jpg
http://i272.photobucket.com/albums/j...pswtzutwdv.jpg
http://i272.photobucket.com/albums/j...pshx0xim24.jpg
to attach backpack/wing armor,the two tabs at the front bottom of the pack simply plug into the stock square shaped holes right behind his head .
the bottom back of the back pack has a tab that will actually overhang and trap in the top of the combiner crotch armor too.
http://i272.photobucket.com/albums/j...psyb081hnn.jpg
http://i272.photobucket.com/albums/j...psnzzsejgu.jpg
http://i272.photobucket.com/albums/j...psyxsjo1ye.jpg
finally,the head..
attach it from front to back.
the back inside of the new noggin has a lip.
this lip hooks under the stock molded in funny bump that's on the back of primes head.
http://i272.photobucket.com/albums/j...psmloyui9a.jpg
finnito....darkness has risen....
http://i272.photobucket.com/albums/j...psjizkfd46.jpg
(there's not alternate mode for all the armor as knowing the commissioner,he's gonna stay in big mode forever in his display lol)
