Re: The collection of AutobotZ24
 

So I spent the week adding some more lighting

Re: The collection of AutobotZ24
 

Damned good stuff, mad jellies

Also like the encased G1 alt modes, a nice idea

Re: The collection of AutobotZ24
 

Which LEDs did you use for your display?

Re: The collection of AutobotZ24
 

Really nice! I like how you displayed the G1 figures. unique! Great work.

Re: The collection of AutobotZ24
 

Radiance RAD-0004 300-LED Flexible Strip LED Lights, 16.4' Cuttable/Linkable Easy Install Lighting Strips, Daylight White https://www.amazon.ca/dp/B01J0WD7M6/..._ZRrAEbENMAP36

Re: The collection of AutobotZ24
 

Thanks!

Re: The collection of AutobotZ24
 

I need some of the brackets to move the glass in different positions
Do you mind if I ask what do you use and where can I buy them??
Thanks
You have some good ideas on positioning your bots.
Nice.

Re: The collection of AutobotZ24
 

I use 3/16" wire rope clips. You can get them at any hardware store

Re: The collection of AutobotZ24
 

Great job bro! Was it hard to wire the LED lights? I never bothered, always seemed like a headache

Re: The collection of AutobotZ24
 

It was a little difficult as I'm not very good at soldering but I managed. Just got to take your time, take some rough measurements and give yourself a bit of extra wire just in case.
What I ended up doing was running a positive and negative wire up the length of the unit and branching off at each level. At each section, I stripped the wire running the length soldered the wires running from the LED strips and heat shrink them.
You can also do the same thing using these blue crimping connectors I got from Canadian Tire.